User Manual Q&AAnswer
Dec 13, 2024 - 02:36 AM
Programming the Besia Universal Replacement Remote for your device is a straightforward process. Here are the step-by-step instructions:
1. Locate the code list: In the user manual provided with the remote, you will find a code list that contains various codes for different brands and models of devices. Find the code list that corresponds to your device type (e.g., TV, DVD player, etc.).
2. Turn on your device: Ensure that the device you want to program the remote for is turned on and in the correct mode (e.g., TV mode for programming a TV).
3. Enter programming mode: Press and hold the "Setup" button on the Besia Universal Replacement Remote until the LED indicator light turns on.
4. Enter the code: Using the number buttons on the remote, enter the four-digit code for your device from the code list. The LED indicator light should blink twice to indicate that the code has been accepted.
5. Test the remote: Point the Besia Universal Replacement Remote towards your device and press the power button. If your device turns off, the programming was successful. If not, repeat steps 3 and 4 with a different code from the list until you find the correct one.
6. Store the code: Once you have found the correct code, press the "Setup" button again to store the code. The LED indicator light should turn off.
7. Test additional functions: After programming the basic power function, you can test other functions like volume control, channel selection, and menu navigation to ensure full compatibility with your device.
If you are unable to find the correct code for your device in the provided code list, you can also try the automatic code search function:
1. Turn on your device and put it in the correct mode.
2. Enter programming mode by pressing and holding the "Setup" button until the LED indicator light turns on.
3. Press the "TV" or corresponding device mode button on the remote (e.g., "DVD," "Audio," etc.).
4. Press and release the "Power" button on the remote repeatedly, waiting a few seconds between each press, until your device turns off. This may take several attempts.
5. Once your device turns off, press the "Setup" button to store the code. The LED indicator light should turn off.
6. Test the remote to ensure all functions are working correctly.
Note: If you accidentally skip over the correct code during the automatic code search, you can press the "Setup" button to backtrack and try the previous code.
If you encounter any difficulties during the programming process, refer to the user manual for further troubleshooting steps or contact Besia customer support for assistance.
Add New Comment