User Manual Q&AAnswer
Dec 13, 2024 - 02:34 AM
To set the alarm on the i-box 79236PI/17 Bedside Alarm Clock, follow these steps:
1. Make sure the alarm clock is in standby mode or clock mode.
2. Press and hold the "Alarm set" button (located on the top of the clock) for 3 seconds. The clock will enter alarm setting mode.
3. Use the "Up" and "Down" buttons to select the desired hour for the alarm.
4. Press the "Alarm set" button again to move to the minute setting.
5. Use the "Up" and "Down" buttons to select the desired minute for the alarm.
6. Press the "Alarm set" button once more to select the alarm source (beep or FM radio).
7. Use the "Up" and "Down" buttons to toggle between the available alarm sources.
8. Repeat steps 3-7 to set a second alarm if desired.
9. Press the "Alarm set" button again to exit the alarm setting mode.
Once the alarms are set, you can enable or disable them by pressing the "Alarm set" button in standby mode. The alarm will cycle through AL1, AL2, AL1 and AL2, and off.
Please refer to the i-box 79236PI/17 Bedside Alarm Clock with Wireless Charging User Manual for more detailed instructions and illustrations.
Add New Comment