User Manual Q&AAnswer
Dec 13, 2024 - 01:56 AM
To start a vehicle using the Acmount P100 3000A Peak Lithium Jump Starter, please follow these step-by-step instructions:
1. Check the remaining power of the jump starter. Make sure it is greater than 20% before attempting to start the vehicle.
2. Insert the plug of the battery clip into the starting output interface (number 5) of the jump starter.
3. Connect the positive (red) and negative (black) poles of the matching battery clip to the corresponding positive and negative poles of the vehicle's battery cable. Ensure a secure connection, red to red and black to black.
4. Twist the vehicle key to the starting gear to start the car. If the engine does not start within 3 seconds, release the key and try again later.
5. After a successful startup, unplug the jump starter from the vehicle's battery and remove the battery clip.
If the vehicle does not start successfully, wait for 1 minute before repeating the above steps. It is important to note that if the auto battery is completely damaged, it may need to be replaced with a new one.
Please refer to the instruction manual for further details and precautions when using the Acmount P100 3000A Peak Lithium Jump Starter.
Add New Comment