User Manual Q&AAnswer
Dec 12, 2024 - 09:20 PM
Programming the Loutoc AKB75095307 Universal Remote Control is a straightforward process. Here are the general steps to program the remote:
1. Identify the device code: Look for the device code in the user manual or the code list provided with the remote control. The code list contains a list of pre-programmed codes for various devices.
2. Turn on the device: Ensure that the device you want to control with the remote is turned on and within range.
3. Enter programming mode: Press and hold the "Setup" button on the remote control until the LED indicator light turns on.
4. Enter the device code: Enter the device code for your specific device using the number buttons on the remote control. The LED indicator light should blink or turn off to indicate successful programming.
5. Test the remote: Point the remote control at the device and press the power button or other relevant buttons to test if the device responds. If it does, the programming was successful. If not, repeat steps 3 and 4 with a different device code.
Note: If the remote control does not have a pre-programmed code for your device, it may have a learning capability. In this case, follow the instructions in the user manual to teach the remote the commands from your original device remote.
For more detailed instructions and troubleshooting tips, refer to the user manual that came with the Loutoc AKB75095307 Universal Remote Control.
Add New Comment