User Manual Q&AAnswer
Dec 12, 2024 - 02:15 AM
To install the ink cartridges in the Epson WorkForce Pro WF-4730 printer, please follow these steps:
1. Lift up the scanner unit until it locks.
2. Gently shake the ink cartridges.
3. Unpack the ink cartridges.
4. Remove only the yellow tape from each ink cartridge.
- For WF-3720: Do not remove any other labels or seals, or ink will leak. Do not touch the green chip on the cartridge.
- For WF-4720/WF-4730/WF-4740: Do not remove any other labels or seals, or ink will leak. Do not touch the green chip on the cartridge.
5. Insert the cartridge in the holder for each color. Press each cartridge down until it clicks. Make sure all cartridges are pushed down into place.
6. Lower the scanner unit.
7. If prompted, follow the instructions on the LCD screen. The printer will start charging the ink, which takes approximately 5 minutes. When you see a completion message on the printer’s LCD screen, charging is complete.
Note: Do not turn off the printer or raise the scanner unit while the printer is charging, as it may waste ink. The printer is designed for use with Epson cartridges only, not third-party cartridges or ink. The cartridges included with the printer are designed for printer setup and not for resale. After some ink is used for charging, the rest is available for printing.
For more detailed information and illustrations, please refer to the Epson C11CG01201 WorkForce Pro WF-4730 Wireless Color Inkjet Printer Installation Manual.
Add New Comment