User Manual Q&AAnswer
Dec 11, 2024 - 10:38 PM
To charge the Dreametech P10 Pro Cordless Stick Vacuum Cleaner, follow these steps:
1. Connect the charging adapter to the wall mount: Rotate the clip in the bottom of the wall mount 90 degrees counterclockwise to remove it from the mount. Insert the charging adapter cord into the notch on the clip. Rotate the clip 90 degrees clockwise until it clicks into place.
2. Install the wall mount: Before installation, measure the wall in the height of 102 cm (40.2 inches) above the ground. Mark and drill two 8 mm (0.315 inch) diameter holes into the wall with an electric drill. Insert the wall plugs into the holes. Align the position holes on the mount with the holes on the wall. Fasten it to the wall with the included screws.
3. Dock the vacuum for charging: Place the vacuum onto the wall mount, ensuring that the charging pins on the vacuum align with the charging contacts on the mount. The vacuum will start charging automatically.
Note: The vacuum cannot be used while charging. Fully charge the vacuum before using it for the first time. This will take about 3 hours. Vacuuming at Turbo mode for a prolonged period will cause the battery to heat up, which increases charging time. Allow the vacuum to cool down for 30 minutes before charging it.
For more detailed information and illustrations, please refer to the Dreametech P10 Pro Cordless Stick Vacuum Cleaner User Manual.
Add New Comment