User Manual Q&AAnswer
Dec 11, 2024 - 06:28 AM
To associate a wireless transmitter to the Lutron RMJS-16R-DV-B PowPak Relay Module, follow these steps:
1. Hold the Relay Toggle button on the PowPak Relay Module for 6 seconds to enter association mode. The load will flash once to confirm.
2. Hold the indicated button on the wireless transmitter (e.g., Pico remote control) for 6 seconds to associate the device. If there is no specific button indicated, hold the "Lights Off" button.
3. Repeat step 2 for any additional wireless transmitters you want to associate.
4. Hold the Relay Toggle button on the PowPak Relay Module for 6 seconds to save the associations.
Note: Make sure there are no other PowPak modules being set up within the same building to avoid incorrect associations. If you need to remove a previously associated wireless transmitter, tap the button used for association on the wireless transmitter three times, on the third tap, hold for three seconds, and then tap three more times.
For more detailed instructions and information, please refer to the Lutron RMJS-16R-DV-B PowPak Relay Module Installation Guide.
Add New Comment