How often should I clean the filters on the Shark Vertex Vacuum with DuoClean PowerFins? (Shark AZ2002 Vertex Lift-Away Upright Vacuum DuoClean PowerFins Instruction Manual)

Answer

manuals.plus

Dec 07, 2024 - 06:05 AM


According to the care instructions provided by Shark, the pre-motor foam and felt filters should be rinsed every 3 months or as needed. The post-motor HEPA filter should be rinsed every 12 months or as needed. It is important to clean the filters regularly to maintain optimal performance.

To clean the pre-motor filters, first, remove the dust cup by sliding up the release latches on both sides of the dust cup handle. Lift the dust cup up and away from the pod. Then, remove the foam and felt filters. Rinse both filters with water only and allow them to air-dry completely for at least 24 hours before reinstalling. Once dry, install the felt filter first, followed by the foam filter. Finally, reinstall the dust cup by placing the bottom of the dust cup into the pod and tilting it until it clicks into place.

To clean the post-motor HEPA filter, pull the latch under the HEPA filter cover and lift off the cover located underneath the Lift-Away logo on the bottom of the pod. Remove the HEPA filter by pressing the side latch. Rinse the HEPA filter with water only and allow it to air-dry completely for at least 24 hours before reinstalling. Once dry, reinstall the HEPA filter and reattach the HEPA filter cover until it clicks into place.

It is important to note that only water should be used to clean the filters. Using any cleaning agents or chemicals may damage the filters and affect the vacuum's performance.