User Manual Q&AAnswer
Dec 07, 2024 - 04:52 AM
To select the correct voltage output for your device using the Belker PA-30120W-ZMX Universal AC/DC Adapter, follow these steps:
1. Check the voltage requirements of your device: Look for the voltage information on your device itself, in the user guide, or on the original power supply. Make sure you know the precise voltage required by your device.
2. Switch off and disconnect the adapter: Before making any adjustments, ensure that the adapter is switched off and disconnected from the power supply and any connected devices.
3. Locate the voltage selection dial or switch: The Belker PA-30120W-ZMX adapter has a voltage selection dial or switch located on the bottom or side of the adapter. It may be marked with voltage options or labeled with voltage values.
4. Adjust the voltage selection: Using your fingers or a small tool, slide or spin the voltage selection switch to the desired output voltage. Make sure the switch is aligned with the appropriate voltage value.
5. Verify the voltage selection: Double-check that the switch is firmly in place and correctly positioned with the selected voltage after choosing the required output voltage.
6. Reconnect the adapter: Once you have confirmed the correct output voltage selection, you can reconnect the adapter to your device and plug it back into the power source.
Important: If the exact voltage required by your device is not listed on the adapter, choose the nearest available option. For example, if your device requires 5.5V, you can select 5V or 6V. However, be cautious not to exceed the maximum output voltage of the adapter.
Always ensure that the polarity of your device matches the adapter's polarity. The Belker PA-30120W-ZMX adapter has a Centre Positive + polarity. If your device requires a Centre Negative - power adaptor, you will need to use a Belker Polarity Reversed Cable to avoid potential damage.
Note: It is recommended to refer to the user guide or consult the manufacturer if you have any specific concerns or questions about using the Belker PA-30120W-ZMX adapter with your device.
Add New Comment