Answer
Dec 07, 2024 - 03:27 AM
To install the SSV Works RZ4-F65A Powersports Speakers, please follow the step-by-step instructions provided in the installation manual. Here is a summary of the installation process:
1. Start at the driver side footwell and remove the factory T40 torx xxxx .
2. Place the driver kick pod into position, aligning the vehicle xxxx bosses with the kick pod brackets.
3. Use two #14 screws to loosely secure the kick pod to the factory xxxx bosses.
4. Reuse the factory T40 torx xxxx to loosely bolt through the lower kick pod bracket to the vehicle panel.
5. Connect the B-H1149 cable to the speaker pod and zip tie all cables to the frame.
6. Once all three screws are in place, go back and re-tighten them.
7. Repeat steps 1-6 to install the passenger kick pod.
Please note that these are general instructions, and it is important to refer to the specific installation manual provided with your product for detailed and accurate instructions. Additionally, if you are unfamiliar with speaker installations, it may be beneficial to consult or hire a professional for assistance.
For any further questions or concerns, please refer to the SSV Works RZ4-F65A Powersports Speakers installation manual or contact SSV Works directly for support.
Add New Comment