User Manual Q&AAnswer
Dec 07, 2024 - 02:10 AM
To set the desired temperature on the Jump Start MTPRTC Digital Controller Heat Mat Thermostat, please follow these steps:
1. Insert the probe approximately 1" – 1½" into the rooting area.
2. Position the thermostat up and away from seedling trays and stray water. DO NOT SUBMERGE THE THERMOSTAT.
3. Plug the heat mat into the thermostat.
4. Plug the thermostat’s power cord into the power source/electrical outlet. The POWER LED lights up.
5. Press the SET button to display the current pre-set temperature. The thermostat’s LED screen shows the current temperature whenever the SET button is not activated.
6. Press and hold the SET button until the LED starts to blink, then you are able to adjust the temperature up or down by pushing the (UP) or (DOWN) arrows. The thermostat’s LED screen shows the numbers as you cycle through them.
7. Press the SET button again to set the chosen temperature. The HEATING light cycles on when the mat is in the process of heating. When the LED is not lit, the mat is not providing heat. The light turns off automatically when the mat reaches the pre-set temperature.
By following these steps, you can easily set the desired temperature on the Jump Start MTPRTC Digital Controller Heat Mat Thermostat. For more detailed instructions and information, please refer to the user manual provided with the product.
Add New Comment