User Manual Q&AAnswer
Dec 05, 2024 - 04:29 AM
To install the Elgato 10LAA9901 Smart LED Light Strip, follow these steps:
1. Clean the surface: Ensure that the surface where you plan to install the light strip is clean and free from dust or debris. This will help the adhesive strip backing adhere properly.
2. Measure and cut: Measure the desired length of the light strip and use scissors to cut it at the designated cut-off points. Be careful to cut along the marked lines to avoid damaging the LEDs.
3. Peel off the backing: Carefully peel off the adhesive backing from the light strip, exposing the sticky side.
4. Stick the light strip: Align the light strip with the desired location and press it firmly onto the surface. Make sure to apply even pressure along the entire length of the strip to ensure proper adhesion.
5. Connect the power adapter: Plug the power adapter into an electrical outlet and connect it to the light strip. Ensure that the connection is secure.
6. Power on and control: Once the light strip is installed and connected, you can power it on and control it using the Elgato Control Center app on your smartphone or compatible device. Follow the instructions in the user manual to set up and control the light strip.
Note: It is important to refer to the user manual for specific installation instructions and safety precautions.
Add New Comment