User Manual Q&AAnswer
Dec 04, 2024 - 10:09 PM
Pairing the Bose 869722-0010 Instrument Transmitter with your S1 Pro+ PA speaker is a simple process. Here are the step-by-step instructions:
1. Make sure both the transmitter and the S1 Pro+ PA speaker are powered on and within close proximity to each other.
2. On the S1 Pro+ PA speaker, locate the wireless RF receiver. It is usually located on the back panel or side of the speaker.
3. Press and hold the pairing button on the wireless RF receiver until the LED indicator starts flashing rapidly. This indicates that the receiver is in pairing mode.
4. On the Bose 869722-0010 Instrument Transmitter, locate the power button. Press and hold the power button until the LED indicator starts flashing rapidly. This indicates that the transmitter is in pairing mode.
5. Within a few seconds, the LED indicator on both the transmitter and the receiver should turn solid, indicating a successful pairing. The devices are now connected and ready to use.
Note: If the LED indicators do not turn solid or if the devices fail to pair, try the following troubleshooting steps:
- Make sure the devices are within the recommended range of 30 feet and there are no obstacles blocking the signal.
- Ensure that both devices have sufficient battery power. If the battery is low, charge the transmitter before attempting to pair again.
- If the devices still fail to pair, try turning them off and on again, then repeat the pairing process.
If you continue to experience issues with pairing, it is recommended to contact Bose customer support for further assistance.
Add New Comment