How do I set up the Samson Stage 200 Handheld Dual-Channel Wireless System? (Samson Stage 200 Handheld Dual User Manual)

Answer

manuals.plus

Dec 03, 2024 - 10:18 AM

Setting up the Samson Stage 200 Handheld Dual-Channel Wireless System is a straightforward process. Here are the step-by-step instructions:

1. Connect the SR200 receiver's power adapter to the rear panel DC input and then plug it into an electrical outlet. Make sure to fully extend the antennas vertically.

2. Connect the appropriate ¼" outputs on the receiver to the input of your mixer, stereo, karaoke machine, or any other line level input.

3. Turn off the VH200 handheld transmitter and rotate the bottom section to expose the battery compartment. Insert two fresh AA batteries into the transmitter, making sure to observe the correct polarity.

4. Place the SR200 receiver in a location where it will be used, ensuring that there is a clear line of sight between the receiver and transmitters. Turn on the power of the SR200 receiver.

5. Turn on the connected amplifier and/or mixer, but keep the volume all the way down. Next, make sure that your transmitter is unmuted and set the Volume Control xxxx on the SR200 fully clockwise (unity gain). Speak or sing into the microphone at a normal performance level while slowly raising the volume of your amplifier/mixer until the desired level is reached.

6. If you hear distortion at the desired volume level or if the AF indicator on the receiver is flashing red, check the gain structure of your audio system. Consult the owner's manual of your mixer and/or amplifier for details. If distortion persists, lower the Volume xxxx on the SR200 to further attenuate the output signal.

7. It's a good idea to do a walk-around in the performance area to ensure coverage. Turn down the level of your audio system, turn on both the transmitter and receiver, and then restore the level of your audio system. While speaking or singing, walk through the entire area that needs to be covered. The RF LED on the front panel of the SR200 should remain lit throughout the coverage area. Try to minimize the distance between the transmitter and receiver for the strongest possible signal.

Following these steps should help you set up the Samson Stage 200 Handheld Dual-Channel Wireless System successfully. For more detailed information and troubleshooting tips, please refer to the owner's manual provided with the product.