User Manual Q&AAnswer
Dec 02, 2024 - 03:08 AM
To adjust the image size when using the Artograph 225360 Tracer Projector, follow these steps:
1. Place your desired artwork or image face-up on a hard surface.
2. Position the Tracer Projector over the artwork, ensuring that it is centered.
3. Switch off the projector by turning the switch to the "O" position.
4. Plug in the projector to a power source.
5. Switch on the projector by turning the switch to the "I" position.
6. Adjust the room lighting to your desired brightness level.
7. To size the image, move the projector closer or farther away from the surface. The distance between the projector and the surface will determine the size of the projected image. Experiment with different distances until you achieve the desired size.
8. Once you have set the desired size, focus the image by adjusting the focus xxxx or lens, if applicable, until the projected image is clear and sharp.
Please refer to the Artograph 225360 Tracer Projector User's Guide for more detailed instructions and illustrations on setting up and operating the projector.
Add New Comment