User Manual Q&AAnswer
Nov 30, 2024 - 05:43 AM
Programming the Viewsonic XY-7080 Replacement Remote Control to work with your Viewsonic projector is a straightforward process. Here are the steps to sync the remote control with your projector:
1. Ensure that your Viewsonic projector is powered on and in a ready state.
2. Locate the remote control code setting on your projector. This setting is usually found in the projector's menu under "System Settings" or a similar section. Refer to your projector's user manual for specific instructions on accessing this setting.
3. On the Viewsonic XY-7080 Replacement Remote Control, press and hold the "ID Set" button and the number button corresponding to the remote control code set in the projector OSD. Hold both buttons for 5 seconds or more.
4. Release the buttons when you see a confirmation message or when the remote control's LED indicator blinks, indicating that the code has been successfully changed.
5. Test the remote control by pressing various buttons to ensure that it is now controlling your Viewsonic projector. If the remote control is not functioning correctly, repeat the steps above to reprogram it.
Note: It is important to set the same remote control code on both the projector and the remote control. If different codes are set, the remote control will not be able to control the projector.
For more detailed instructions or troubleshooting assistance, refer to the user manual that comes with the Viewsonic XY-7080 Replacement Remote Control.
Add New Comment