User Manual Q&AAnswer
Nov 28, 2024 - 12:50 AM
To install a hard drive in the Microseven M7NVR-4K08CHPOE Network Video Recorder, please follow these steps:
1. Ensure that you have a compatible hard drive for the NVR. The M7NVR-4K08CHPOE supports hard drives up to 10TB in size and is compatible with Seagate Skyhawk and WD Purple hard drives.
2. Power off the NVR and disconnect it from the power source.
3. Remove the screws on the NVR casing to open it.
4. Locate the SATA port inside the NVR. It is usually labeled as "SATA" and may have a connector attached to it.
5. Connect the SATA data cable from the hard drive to the SATA port inside the NVR. Ensure that it is securely connected.
6. Connect the SATA power cable from the NVR's power supply to the power connector on the hard drive.
7. Carefully place the hard drive inside the NVR casing, ensuring that it is properly aligned with the mounting holes.
8. Secure the hard drive in place using the screws provided.
9. Close the NVR casing and tighten the screws to secure it.
10. Reconnect the NVR to the power source.
11. Power on the NVR and wait for it to initialize. The NVR should automatically detect the newly installed hard drive.
12. To verify that the hard drive is recognized, navigate to the NVR's settings menu and check the storage capacity.
Please refer to the user manual for more detailed instructions and illustrations specific to your NVR model.
Add New Comment