User Manual Q&AAnswer
Nov 27, 2024 - 10:56 PM
To connect the VHF-4005 microphone system to your audio equipment or mixer, you will need audio cables (usually 1/4-inch or XLR connectors) that are compatible with your equipment. Here are the steps to make the connection:
1. Ensure that the main power switch on the VHF-4005 receiver is turned off.
2. Locate the audio output options on the back panel of the VHF-4005 receiver.
3. If you have a mixer with individual channel inputs, you can use the XLR outputs for each microphone channel. Connect one end of an XLR cable to the corresponding channel output on the VHF-4005 receiver. Connect the other end of the XLR cable to the input on your mixer that corresponds to the desired microphone channel. Repeat this step for each microphone channel.
4. If you have limited inputs on your mixer or prefer to mix all microphone signals together, you can use the 1/4" mixed output. Connect one end of a 1/4" cable to the 1/4" mixed output on the rear panel of the VHF-4005 receiver. Connect the other end of the 1/4" cable to an available input on your mixer or amplifier.
5. Once all the connections are made, ensure that the volume levels on your mixer or amplifier are set appropriately for each microphone channel.
6. Turn on the VHF-4005 receiver and adjust the channel volumes on the front panel of the receiver as needed.
Please refer to the owner's manual for additional information and troubleshooting tips.
Add New Comment