User Manual Q&AAnswer
Nov 27, 2024 - 10:16 PM
Programming user codes on the Kwikset 98690-002 Smart Garage Door Opener is a straightforward process. Here are the step-by-step instructions:
1. Ensure that the device is installed and functioning correctly, as described in the installation instructions provided in the user manual.
2. Locate the keypad on the Smart Garage Door Opener. It is typically located on the exterior side of the garage door.
3. Press the "Program" button on the keypad. This will activate the programming mode.
4. Enter your existing user code (if you have already set one) or the default user code provided in the user manual. This will allow you to access the programming menu.
5. Once in the programming menu, follow the instructions provided in the user manual to add or delete user codes. Typically, you will need to enter a master code or administrator code to access this menu.
6. Enter the desired user code that you want to program. The user code can be a combination of numbers, typically between 4 and 8 digits long.
7. After entering the user code, press the "Program" button again to confirm and save the code.
8. Repeat steps 6 and 7 for each additional user code you want to program.
9. Test the user codes by entering them on the keypad and verifying that the garage door unlocks or locks accordingly.
It's important to note that the specific steps for programming user codes may vary slightly depending on the model and firmware version of the Kwikset 98690-002 Smart Garage Door Opener. For precise instructions, refer to the user manual provided with the product.
Add New Comment