Answer
Nov 10, 2024 - 10:54 PM
To connect the DOACT Phantom(CH1-2) Audio Mixer to your computer for digital recording, follow these steps:
1. Ensure that your computer has an available USB port and that the mixer is powered off.
2. Use a USB cable (not included) to connect the USB port on the mixer to an available USB port on your computer.
3. Power on the DOACT Phantom(CH1-2) Audio Mixer.
4. On your computer, open your preferred digital audio workstation (DAW) software or recording software.
5. In the software's settings or preferences, select the DOACT Phantom(CH1-2) Audio Mixer as the audio input device. Refer to your software's user manual for specific instructions on selecting audio input devices.
6. Configure the input channels in your software to correspond with the channels you are using on the mixer. For example, if you have a microphone connected to CH1 on the mixer, set the corresponding input channel in your software to CH1.
7. Set the desired input gain levels on the mixer for each channel by adjusting the gain control knobs. It is recommended to start with lower gain levels and gradually increase them while monitoring the audio signal to avoid clipping or distortion.
8. Adjust any other settings in your software, such as sample rate and buffer size, according to your preferences and requirements.
9. Begin recording by pressing the appropriate record button in your software. You should now be able to capture audio from the DOACT Phantom(CH1-2) Audio Mixer onto your computer.
Note: It is important to consult the user manual of your specific software for detailed instructions on recording and configuring audio input devices.
Add New Comment