User Manual Q&AAnswer
Nov 08, 2024 - 05:29 AM
To connect your dynamic microphone to the Recordio GAX-CT12 Professional 8 Channel BT Audio Mixer, follow these steps:
1. Locate the XLR input on the mixer. The XLR inputs are typically labeled with numbers corresponding to the channel numbers on the mixer.
2. Plug one end of an XLR cable into the XLR output of your dynamic microphone.
3. Plug the other end of the XLR cable into the XLR input of the desired channel on the mixer. Make sure to match the channel number on the mixer with the corresponding XLR input.
4. Once connected, adjust the volume control for the channel to an appropriate level. You can find the volume control xxxx for each channel on the mixer.
5. If your dynamic microphone does not require phantom power, you can skip this step. However, if your microphone requires phantom power (e.g., condenser microphones), make sure to activate the phantom power switch for the corresponding channel on the mixer. The phantom power switch is usually labeled "Phantom" or "48V" and is located near the XLR input.
6. Perform a soundcheck by speaking or singing into the microphone and monitoring the audio levels on the LED level meters or through headphones connected to the mixer's headphone output.
By following these steps, you should be able to properly connect your dynamic microphone to the Recordio GAX-CT12 Professional 8 Channel BT Audio Mixer and start recording vocals. For more detailed instructions and information, please refer to the user manual provided with the mixer.
Add New Comment