User Manual Q&AAnswer
Nov 08, 2024 - 04:55 AM
To install the BAZOOKA BT6024DVC Dual Passive-Tube Subwoofer in your car, follow these steps:
1. Choose a suitable location in the rear of your vehicle where you want to place the subwoofer. The woofer (grill end) should be facing into a corner, and ideally, there should be 2 to 4 inches of space between the woofer and the corner it is pointing into.
2. Carefully check the mounting area to ensure that the mounting screws will not damage the gas tank, electrical wiring, fuel lines, or the spare tire during the installation of the strap bases.
3. xxxx the strap mounting bases securely to a rigid surface that is part of, or anchored to, the structure of the vehicle.
4. With the top side of the buckle facing up, lace the strap through the mounting base. After the strap is completely laced through the mounting base, make a loop with the strap where it runs across the middle of the base.
5. Place each mounting base under the Bass Tubes® enclosure so that the apex at the bottom of the tube sits inside the mounting base.
6. Move the bases so that they are spaced approximately 3" from each end of the enclosure.
7. xxxx each mounting base securely in place with the provided screws.
8. Remove any slack in the strap by feeding it out of the mounting base on the loose end of the strap opposite the buckle.
9. Place the Bass Tubes® enclosure on the mounting bases and fasten the buckles. The strap should loop through the buckle and be tightened securely by holding the strap in place with one hand and pulling the loose end away from the buckle, but against the cabinet.
10. Check the straps regularly to ensure that the Bass Tubes® enclosure is mounted securely in place, as the straps may stretch or loosen over time due to vehicle movement.
For more detailed instructions and illustrations, refer to the user manual provided with the BAZOOKA BT6024DVC Dual Passive-Tube Subwoofer.
Add New Comment