User Manual Q&AAnswer
Nov 07, 2024 - 11:32 PM
Installing the AUDIOVOX TRY-32 3-Way Stereo Speaker System in your car can be done by following the provided installation guide. Here is a step-by-step guide to help you with the installation process:
1. Consider speaker placement: Before beginning the installation, it's important to consider the direction of sound and sound directionality. Aim the speakers at the listener and avoid directing them towards the car floor, except for rear speakers behind the rear seat. Install tweeters and mid-range speakers aimed towards the passenger area and as high as possible. Choose solid mounting panels for your speakers and ensure they have enough breathing room.
2. Use factory openings if available: Car manufacturers often provide pre-cut openings for speaker installations. These openings are designed to simplify the installation process and fit within the design constraints of the vehicle. If your car has pre-cut openings, it's generally advised to use them. However, be cautious of openings near the floor and consider removing door upholstery to uncover additional speaker location options higher up on the door.
3. Cutting speaker openings: If your car doesn't have pre-cut openings or you want to explore other speaker location options, you may need to cut speaker openings. Most cars have factory pre-cut openings in the rear deck or package shelf. Inspect these openings from the underside of the panel using the trunk. Compare the size and shape of the existing holes with the speakers you've purchased. Use a sharp serrated steak knife to cut out the oval opening in the fiber panel covering the existing hole in the steel sub-liner. Create four speaker mounting holes and widen them to a 1/16" diameter.
4. Grille installation: The grille, which comes included with the speaker, has threaded rods projecting from its back. Fit the rods into the holes in each section of the grille. Place the grille on the shelf, allowing the studs to pass through the holes you previously made. Set the speaker below the shelf and align it over the four studs of the grille. Secure it using the provided hex nuts or screws.
5. Wiring the speakers: Follow the specific instructions for your model to wire the speakers correctly. Ensure you use high-quality speaker wiring to handle the normal power load of the speakers.
It's important to note that the provided information is a general guide, and it's always recommended to consult the installation guide specific to the AUDIOVOX TRY-32 3-Way Stereo Speaker System for detailed instructions and any additional considerations.
Add New Comment