Answer
Nov 07, 2024 - 11:31 PM
Sure! Here are the step-by-step instructions for installing the M&S SYSTEMS DMC1RW Remote Station Speaker:
1. Strip approximately 4 inches of jacket from the CAT5 wire at each room station location.
2. Separate the colored conductors from each other and strip ½ inch of insulation from each conductor.
3. Connect each colored conductor to its respective xxxx terminal on the room station.
4. Mount each room station to its mounting ring using the two screws provided.
5. For the patio station, strip approximately 4 inches of jacket from the CAT5 wire and separate the colored conductors.
6. Strip ½ inch of insulation from each conductor and connect each colored conductor together using wire nuts.
7. Mount the patio station to the housing using the 2 screws provided.
8. For the satellite volume control, strip approximately 4 inches of jacket from the wires and separate the colored conductors.
9. Connect the drain wires together using a wire nut and connect each colored conductor to its respective wire.
10. Connect the blue and violet wires to the corresponding terminals of the satellite speakers.
11. Mount the satellite volume control to the single gang box using the two screws provided.
12. For the external music source, use the labels provided to mark the respective cables and connect them to the plate.
13. Mount the plate using the two screws provided.
14. For the door stations, strip approximately 4 inches of jacket from the wire and separate the colored conductors.
15. Strip ½ inch of insulation from each conductor and connect them to the appropriate terminals on the bell button and speaker.
16. Mount the door station to the housing using the two screws provided.
17. Gather all room station and door station cables and cut the cable ends to the same length.
18. Strip approximately 2 inches of insulation from each CAT5 cable and untwist the individual wire pairs.
19. Insert each wire pair into the correct connector location on the dmc1 master and close the connector.
20. Insert each cable connector into its proper location on the dmc1 master.
21. Install the optional chime module in the wall housing by pressing it over the plastic standoffs.
22. Suspend the master unit from the wall housing using the third-hand wire.
23. Connect the red and black wires of the door station cables to the red and black door speaker terminals on the dmc1 master.
24. Connect the orange wires from the door stations to the common terminal on the chime module.
25. Connect each yellow wire to a note selection terminal and plug in the modular chime plug.
26. Connect the FM dipole twin lead antenna to the FM terminals on the dmc1 master.
27. Connect the orange AM antenna wire to the AM terminal on the master.
28. To install the optional wireless remote control receiver module, attach it to the wall housing using the Velcro strips provided.
29. Place the white antenna lead through the hole provided in the wall housing.
30. Connect the wire harness from the remote control receiver module to the connector labeled REMOTE on the master.
31. Connect the VM127X cables from the remote power transformer and the door release striker for the door release function.
32. Connect the MS7X5SC cable from the dmc1 master to the 8-pin terminal block on the amplifier module.
33. Connect each of the 7 colored wires and shield drain wire from the MS7X5SC cable to the terminal block.
34. Connect the volume control cables to the shield terminal on the remote amplifier and connect each colored wire to its respective terminal.
35. Set the stereo/mono select jumper on the remote amplifier according to your configuration.
36. Plug in the RCA phono plugs to the jacks as marked for the source equipment.
37. After all connections have been made, insert the power plug into the transformer and secure the master to the wall housing.
38. Install the speaker panel on the master.
Please refer to the M&S SYSTEMS DMC1RW Remote Station Speaker User Manual for more detailed instructions and illustrations.
Add New Comment