Answer
Nov 07, 2024 - 10:27 PM
To connect speakers to the TOA BG-2035 Channel Mixer Amplifier, follow these steps:
1. Identify the speaker output terminals on the rear panel of the amplifier. These terminals are labeled as 4 Ω, 25 V, and 70 V.
2. Choose the appropriate speaker output based on your speaker system. If you are using a 4 Ω speaker, connect it to the 4 Ω output terminal. If you are using a 25 V or 70 V speaker system, connect it to the corresponding output terminal.
3. Loosen the terminal screws on the speaker output terminal block.
4. Insert the positive (+) wire of the speaker into the corresponding positive (+) terminal on the terminal block. Ensure a secure connection.
5. Insert the negative (-) wire of the speaker into the corresponding negative (-) terminal on the terminal block. Ensure a secure connection.
6. Tighten the terminal screws to secure the speaker wires in place. Ensure a tight connection to prevent any signal loss or disconnection.
7. Repeat the above steps for each speaker you wish to connect to the amplifier.
Note: It is important to use appropriate gauge speaker wire for your speaker system and to follow any specific instructions provided by the speaker manufacturer. Additionally, ensure that the total speaker load impedance does not exceed the amplifier's specifications.
For further details and illustrations, please refer to the "Output Connections" section of the TOA BG-2035 Channel Mixer Amplifier Operating Instructions manual.
Add New Comment