User Manual Q&AAnswer
Nov 07, 2024 - 10:12 PM
To install the Memphis Audio MXASB20V2 Bluetooth Soundbar Speaker, follow these steps:
1. Wiring:
- Connect the red wire (constant 12V) to the vehicle's positive battery terminal.
- Connect the black wire (chassis ground) to the vehicle's chassis or negative battery terminal.
2. Optional Wiring:
- The green female 3.5mm jack can be used for an optional auxiliary input. Connect any audio device via the 3.5mm jack.
- The white female 3.5mm jack is a low-level audio out designed to drive external amplifiers. This allows you to use the MXASB20V2 as the main source while adding more audio components to your system.
3. Mounting:
- Take the 10mm bolt with a lock washer and place it through the bottom of the clamp, then slightly thread it into the dove-tailed piece.
- Slide the assembly into one of the three dove-tail recessed areas to position the unit at the desired angle.
- Tighten the bolt to securely hold the bracket in place.
- Repeat this step for both included brackets. Both brackets must be used during installation.
- Use the top half of the bracket and tighten it down over the bar using the four included bolts (two per clamp).
- Tighten the bolts until the unit is secure.
4. Connect wires:
- Connect the power, ground, and optional auxiliary input or audio output wires.
For more detailed instructions and illustrations, refer to the Memphis Audio MXASB20V2 Bluetooth Soundbar Speaker Installation Guide.
Add New Comment