User Manual Q&AAnswer
Nov 07, 2024 - 09:56 PM
To mount the Jamo 3A2 All Weather Satellite Speaker, follow these steps:
1. Assemble the bracket: The brackets come pre-assembled, but if you need to disassemble them for painting, reassemble them as follows:
a. Place the curved bracket (a) between the wall bracket (b) and wall bracket cover (c).
b. Insert two 1” Allen bolts (d) through the wall bracket into the wall bracket cover and tighten with the supplied Allen wrench.
c. Insert two ½” Allen bolts (e) into each side of the wall bracket and tighten towards the curved bracket.
2. Mount the bracket: The bracket can be mounted for horizontal or vertical placement of the speaker. Mount the bracket with four screws appropriate for the surface it will be mounted to (wood, brick, concrete, or other). Use the hole (f) in the middle of the bracket to run the speaker wire through if desired. Cover the screws with four xxxx plugs (g).
3. Mount the port plugs: If the front of the speaker will be exposed to rain directly entering the bass reflex ports (under the grill), you should close the ports to avoid water damage. Remove the grill (h) from the speaker and insert two port plugs (i) into the bass ports. Re-install the grill. Note that closing the ports will result in less bass reproduction.
4. Connect speaker wires: Loosen the speaker terminals by turning them counterclockwise. Strip ½”/12 mm insulation off each wire and twist the strands on each wire to form a solid wire. Insert one wire into each terminal and tighten the terminal by turning it clockwise. Make sure the positive (+) wire is connected to the red terminal and the negative (-) wire is connected to the black terminal for correct phasing.
5. Adjust the I/O 3T model (if applicable): If you have the I/O 3T model, which is for 70V or 100V line installation, adjust the switch located next to the terminals to the desired level (10W, 5W, 2.5W, or 1.25W) on each speaker.
6. Mount the speaker: Place the speaker inside the curved bracket and insert thumb screws (j) through each end of the curved bracket into the speaker. Adjust the speaker to the desired angle and tighten the thumb screws. Install the covers (k) over the thumb screws. The curved bracket can be adjusted in the wall bracket by loosening the two ½” Allen bolts (e) and re-tightening them after adjustment.
Please refer to the Jamo 3A2 All Weather Satellite Speaker User Manual for more detailed instructions and illustrations.
Add New Comment