User Manual Q&AAnswer
Nov 07, 2024 - 02:36 AM
To connect the Russound A-K5L Audio & Video Volume Control to your audio system, follow these steps:
1. Use a CAT-5 cable with an RJ45 connector to connect the RJ45 input on the A-K5L to the CAT-5 output on your A-BUS hub/controller. Make sure to use the T568A wiring standard.
2. Connect a pair of 8-ohm speakers to the Speaker Output connections on the A-K5L. Use xxxx -down terminals and up to 16 gauge speaker wire.
3. If you want to use an external amplifier or powered subwoofer, connect it to the Line Out connection on the A-K5L. Use a 22AWG four conductor, two-pair twisted shielded cable to connect to the Left positive (+) and negative (-), and Right positive (+) and negative (-) xxxx -down terminals on the back of the A-K5L. Terminate the cable to the rear solder lugs of a wall plate fitted with two RCA jacks on its front. Use RCA cables to connect the amp or subwoofer to the wall plate for audio signal feed.
Please refer to the installation manual for more detailed instructions and diagrams.
Add New Comment