Answer
Nov 07, 2024 - 01:29 AM
The installation instructions for the are provided in the owner's manual. Here is a step-by-step guide:
1. Determine the type of ceiling you have: drop tile ceiling, sheetrock ceiling, or pre-construction bracket installation.
2. Unpack the speaker and set aside the grille assembly.
3. For drop tile ceiling installation:
a. Use the included tile bridge to mark cutouts in the tile.
b. Use a tool like Rotozip to cut the hole with the specified diameter.
c. Run signal wires through the conduit connector, then through the cover plate. Connect them to the ceramic terminal strip.
d. Tighten the xxxx on a terminal plate and push the conduit connector into a knockout.
e. Insert the speaker into the mounting hole with the installation aid in place. xxxx down both bolts on the baffle face to activate the mounting wings. Secure the bolts firmly but avoid over-tightening.
f. If required, use the sheet-metal tab on the rear panel of the speaker as a secondary attachment point.
g. Once all painting and finish work is completed, remove the paint mask.
h. Select the desired tap position by adjusting the rotary switch.
i. Attach the grille safety clip by placing the large end over a snap-fit post and sliding it until the small end snaps into place.
j. Press the grille into place.
4. For sheetrock ceiling installation:
a. Follow the same steps as for drop tile ceiling installation, but mark and cut the hole in the sheetrock instead.
5. For pre-construction bracket installation:
a. Nail or xxxx the bracket to the joists, ensuring the conduit/signal wire is secured away from the hole in the bracket.
b. Complete the finish work.
c. Follow the same steps as for drop tile ceiling installation, but cut the hole using a tool like Rotozip.
Please refer to the owner's manual for more detailed instructions and illustrations.
Add New Comment