User Manual Q&AAnswer
Nov 06, 2024 - 09:26 PM
To select the power level for the Bogen OPS1 Orbit Pendant Speaker, you need to use the front-mounted selector switch. Here are the steps to follow:
1. Remove the speaker grille before selecting the power level. Refer to the "Grill Installation & Removal" section in the user manual for instructions on how to remove the grille.
2. Locate the front-mounted selector switch, which is located under the grille.
3. Use a small flat-blade screwdriver to turn the xxxx on the selector switch. Turn the xxxx until the slot points to the power level you require.
- For 70V and 100V high-impedance systems, both power setting scales are labeled on the speakers. On the 100V scale, the last position clockwise is marked with a ® symbol, indicating that it is not available. Do not use this position in a 100V system.
- For low-impedance systems, the fully counterclockwise position of the setting switch is the 16-ohm position. This setting is suitable for use with low-impedance amplifiers that typically support 4- or 8-ohm speakers.
4. Once you have selected the desired power level, you can reinstall the speaker grille. Refer to the "Grill Installation & Removal" section for instructions on how to properly install the grille.
By following these steps, you can ensure that you are using the correct power level for your audio system with the Bogen OPS1 Orbit Pendant Speaker.
Add New Comment