Answer
Nov 06, 2024 - 09:17 PM
To connect the Lauten Audio LT-386 microphone to your recording setup, follow these steps:
1. Make sure the phantom power and gain on your recording interface/microphone preamp are turned off.
2. Check that the voltage switch on the back of the power supply is set correctly for the voltage in your country (115V for 100 to 120V, 230V for 220 to 240V).
3. Turn off the on/off switch on the power supply and connect the power cord from the power supply to a power outlet.
4. Connect the black, male, 5-pin connector of the tube mic cable to the 5-pin female connector of the power supply.
5. Connect the silver, female, end of the 5-pin tube mic cable to the bottom of the 5-pin male connector on the microphone.
6. Securely connect the female end of a standard 3-pin XLR microphone cable to the 3-pin male connector on the power supply and the male end to your recording interface/microphone preamp/mixer.
For more detailed information and illustrations, please refer to the "Connections" section of the Lauten Audio LT-386 Condenser Microphone Operating Manual.
Add New Comment