Answer
Nov 04, 2024 - 12:18 AM
To power on the MINOLTA VIEW 35mm Slide and Film Viewer, please follow these steps:
1. Make sure the USB AC adapter is properly connected to a power source or insert 4 AA batteries into the viewer for power.
2. Locate the power button on the viewer. It is usually located on the front or side of the device.
3. Press and hold the power button for a few seconds until the viewer powers on.
4. Once the viewer is powered on, you should see the LED backlight illuminate, indicating that it is ready for use.
If the viewer does not power on even after following these steps, please check the following:
- Ensure that the USB AC adapter is securely connected to both the viewer and the power source.
- Verify that the power source is functioning correctly by trying a different outlet or power supply.
- If you are using batteries, make sure they are inserted correctly and are not depleted. Try replacing them with fresh batteries.
If the issue persists, please refer to the troubleshooting section in the user manual or contact customer support for further assistance.
Add New Comment