User Manual Q&AAnswer
Nov 01, 2024 - 04:32 AM
To connect the Astatic PDC1 SWR Power Meter to your CB radio, please follow these steps:
1. Locate the ANT (antenna) and TRANS (transmitter) connectors on the back of the meter. These connectors are labeled for easy identification.
2. Identify the corresponding ANT and TRANS connectors on your CB radio. They are typically labeled as well.
3. Take a coaxial cable with PL-259 connectors on both ends. Connect one end of the cable to the ANT connector on the meter.
4. Connect the other end of the coaxial cable to the ANT connector on your CB radio.
5. Take another coaxial cable with PL-259 connectors on both ends. Connect one end of this cable to the TRANS connector on the meter.
6. Connect the other end of the coaxial cable to the TRANS connector on your CB radio.
7. Ensure that all connections are secure and tightly screwed in to prevent any signal loss or interference.
Once you have successfully connected the Astatic PDC1 SWR Power Meter to your CB radio, you can proceed to use the meter for SWR and power measurements. Please refer to the manual for detailed instructions on how to operate the meter and interpret the readings.
For any additional assistance or troubleshooting, please consult the Astatic customer service through the provided contact information.
Add New Comment