User Manual Q&AAnswer
Nov 01, 2024 - 04:24 AM
To set batch quantities for coin rolls on the Cassida C300, follow these steps:
1. Press and hold the "+" button on the control panel for approximately three seconds until "L" is shown on the display. This will automatically program each coin denomination for standard bank coin roll sizes.
2. The default batch quantities for each denomination are as follows:
- $2: 25 (Canadian model only)
- $1: 25
- 25¢: 40
- 10¢: 50
- 5¢: 40
- 1¢: 50
(Note: Denominations and quantities may vary for different countries.)
3. If you want to adjust the batch quantities for specific denominations, you can do so by pressing the "BAT" button to access the batch screen.
4. Press the "SET" button to select the desired denomination for which you want to set the batch quantity.
5. Use the "BAT" button to cycle through the available batch quantities (0, 10, 20, 25, 50, 80, 100, 120, 150, 200, 300, 400, 500, 600, 700, 800, 900).
6. Fine adjustments to the batch quantity can be made by pressing the "-" or "+" button.
7. Repeat steps 4-6 to set the desired batch quantities for other coin denominations.
8. Once all the denominations are set, press the "START/STOP" button to start counting.
Note: The Cassida C300 will stop when the desired batch quantity is completed for any of the denominations. The display will show "BAT FULL" on the top left corner with the denomination line blinking. To resume counting, press the "START/STOP" button.
Remember to consult the user manual for additional information and troubleshooting tips.
Add New Comment