Answer
Nov 01, 2024 - 03:11 AM
Installing the ELEGRP R1615D42-WH Wall Outlet with USB Ports is a relatively straightforward process. Here are the step-by-step instructions:
1. Turn off the power: Before starting the installation, make sure to turn off the power to the outlet at the breaker to avoid any electrical hazards.
2. Remove the old outlet: Remove the existing wall outlet by unscrewing the mounting screws and gently pulling it out of the wall box. Take note of the wiring connections.
3. Connect the wires: Connect the wires from the wall box to the corresponding terminals on the ELEGRP R1615D42-WH outlet. Typically, there will be two black (hot) wires, two white (neutral) wires, and two green or bare copper (ground) wires. Follow the manufacturer's instructions or consult a qualified electrician if you are unsure about the wiring connections.
4. Secure the outlet: Once the wires are properly connected, carefully push the outlet into the wall box and secure it in place using the provided installation screws. Make sure the outlet is flush with the wall.
5. Attach the wall plate: Attach the included wall plate to the outlet by aligning the xxxx holes and tightening the screws. The wall plate should cover the outlet completely.
6. Turn on the power: After the installation is complete, turn the power back on at the breaker to restore electricity to the outlet.
7. Test the outlet: To ensure the installation was successful, test the outlet using a standard plug and a USB device. Plug in a device into the AC outlets and connect a USB device to the USB ports. If everything is working correctly, the devices should receive power.
Please note that electrical work should be performed by a qualified electrician to ensure safety and compliance with local electrical codes. Always follow the manufacturer's instructions and consult a professional if you have any doubts or concerns.
Add New Comment