Answer
Nov 01, 2024 - 02:59 AM
To install the ELEGRP R1815D60CCA-WH Wall Outlet, please follow these step-by-step instructions:
1. Turn off the power to the outlet location where you're installing the ELEGRP wall outlet. This can be done by switching off the circuit breaker or removing the appropriate fuse.
2. Remove the existing outlet by unscrewing the mounting screws and gently pulling it out from the wall box. Take note of the wiring connections.
3. Detach the wiring from the old outlet. Typically, you will find three wires: black (hot), white (neutral), and green or bare copper (ground). Carefully loosen the terminal screws or release the wires from the push-in connectors.
4. Connect the wires to the new ELEGRP wall outlet. Attach the black wire to the brass xxxx , the white wire to the silver xxxx , and the ground wire to the green xxxx . Make sure the wires are securely fastened.
5. Carefully push the wires back into the wall box and align the ELEGRP wall outlet with the xxxx holes. Use the provided installation screws to secure the outlet to the wall box. Do not over-tighten the screws.
6. Attach the included wall plate by aligning it with the outlet and screwing it into place using the provided screws.
7. Turn the power back on at the circuit breaker or by replacing the fuse.
8. Test the outlet by plugging in a device or using a voltage tester to ensure it is functioning correctly.
Please note that these instructions are a general guide, and it is always recommended to consult a qualified electrician or refer to the product's specific installation guide for your safety and to comply with local electrical codes and regulations.
Add New Comment