Answer
Oct 31, 2024 - 10:42 PM
To install the BELL MX1050S Weatherproof Universal Flip Cover, follow these steps:
1. Turn off power to the receptacle.
2. Configure the base as shown in the installation instructions. Make sure the electrical box is flush or slightly behind the finished surface, and the receptacle is flush with the finished surface.
3. Back out the box screws and place the gasket over the screws.
4. Using the keyholes, place the base over the screws and against the gasket.
5. Tighten the screws, but do not over-tighten the mounting hardware.
6. If the device does not protrude through the base or duplex/round adapters, use UL approved spacers (not included) to move the device forward in the box.
7. Ensure that the base is installed on a smooth, flat surface. If installing on irregular surfaces like brick or cedar siding, apply a 1/4 inch bead of nonhardening silicone caulk (not included) between the gasket and the mounting surface for a weatherproof seal.
8. Caution: Improper installation of any electrical device can cause serious injury or death.
Please refer to the installation instructions provided in the user manual for more detailed guidance and illustrations.
Add New Comment