Answer
Oct 31, 2024 - 03:56 AM
To install the Leviton T5633-W Wall Charger Tamper-Resistant, please follow these steps:
1. Before starting the installation, turn off the power at the circuit breaker or fuse and test that the power is off before wiring to avoid fire, shock, or death.
2. Ensure that you have a wall box measuring at least 2" x 2-1/2" (standard single gang electrical wall box) and wired according to NEC article 314 box fill requirements.
3. Connect the wires per the provided wiring diagram. The back and side wire terminals accept #14-#12 AWG copper or copper-clad wires.
- To Side Wire: Remove the insulation from each circuit conductor per the strip gauge on the device (approximately 3/4" or 1.9 cm). Loop the wires clockwise 3/4 turn around the terminal screws and tighten the screws over the wire loop using a torque value of 14-18 in-lbs.
- To Back Wire: Remove the insulation from each circuit conductor (approximately 1/2" or 1.3 cm). Insert the straight wires under the clamps next to the appropriate terminal screws and tighten the screws firmly.
4. Mount the device in the wall box using the provided screws and then attach the wallplate.
5. Restore power at the circuit breaker or fuse. The installation is now complete.
Please note that if you are unsure about any part of these instructions, it is recommended to consult an electrician for assistance.
Add New Comment