User Manual Q&AAnswer
Oct 31, 2024 - 02:53 AM
To adjust the sensitivity level on the GTC FF310 Circuit Finder and Tracer, follow these steps:
1. Make sure the FF310R receiver unit is turned on.
2. Press and hold the On/Off button on the FF310R for approximately 3 seconds until you hear a beeping sound and see flashing lights. This indicates the current sensitivity level setting.
3. While still holding the On/Off button, the FF310R will cycle to the next sensitivity setting. The pattern of flashing lights and beeping sounds will indicate the sensitivity level:
- Low Sensitivity: Single (1) flash and beep.
- Medium Sensitivity: Double (2) flashes and beeps.
- High Sensitivity: Triple (3) flashes and beeps.
4. Release the On/Off button when the desired sensitivity level is reached.
5. The FF310R will retain the last selected sensitivity setting even when turned off.
Note: It is recommended to start with the lowest sensitivity level and increase it if needed. Adjusting the sensitivity level allows you to choose the degree of sensitivity most suitable for the particular detection being performed.
Add New Comment