Answer
Oct 30, 2024 - 10:35 PM
Installation Process:
1. Turn off the power: Before starting the installation process, make sure to deactivate the power supply to the outlet by switching off the circuit breaker or removing the fuse.
2. Remove the existing outlet: Unscrew the wall plate and remove the screws holding the old outlet in place. Carefully disconnect the wires from the old outlet.
3. Connect the wires to the new outlet: Take note of the wiring configuration of the old outlet. The VERSAF Tamper GFCI Outlet Resistant typically has three wires: a black (hot) wire, a white (neutral) wire, and a green or bare copper (ground) wire. Connect the corresponding wires to the appropriate terminals on the new outlet. Use wire nuts or terminal screws to secure the connections.
4. Secure the outlet in place: Gently push the wires back into the electrical box and align the outlet with the xxxx holes. Insert the screws provided with the outlet and tighten them to secure the outlet to the wall.
5. Attach the wall plate: Place the included white decor wall plate over the outlet and align the xxxx holes. Insert the screws and tighten them to secure the wall plate.
6. Restore power: Once the outlet is securely installed, restore power by switching on the circuit breaker or replacing the fuse.
Please note that this is a general overview of the installation process. It is always recommended to consult the user manual provided with the VERSAF Tamper GFCI Outlet Resistant for specific instructions and safety guidelines. If you are unsure or uncomfortable with the installation process, it is advisable to seek the assistance of a licensed electrician.
Add New Comment