Answer
Oct 30, 2024 - 09:38 PM
To install the GE Home Electrical 44047 Tamper Resistant GFCI Receptacle, follow these steps:
1. Turn off the power: Before starting the installation, turn off the power to the circuit at the main electrical panel.
2. Remove the existing outlet: If there is an existing outlet in the electrical box, carefully remove it by unscrewing the mounting screws and disconnecting the wires.
3. Prepare the wires: Strip about 3/4 inch of insulation from the ends of the wires in the electrical box. Make sure the wires are clean and free from any damage.
4. Connect the wires: Connect the black (hot) wire to the brass-colored xxxx terminal, the white (neutral) wire to the silver-colored xxxx terminal, and the green or bare copper (ground) wire to the green xxxx terminal on the GFCI receptacle. Use wire connectors or screws to secure the connections.
5. Mount the GFCI receptacle: Carefully insert the GFCI receptacle into the electrical box, aligning the xxxx holes with the mounting holes in the box. Secure the receptacle in place using the provided mounting screws.
6. Test the GFCI functionality: Once the receptacle is securely mounted, turn on the power at the main electrical panel. Press the "Test" button on the GFCI receptacle to simulate a ground fault. The GFCI should trip and cut off power. Press the "Reset" button to restore power. If the GFCI does not trip or reset properly, consult the troubleshooting section of the user manual or contact GE's customer support for assistance.
7. Complete the installation: Once the GFCI functionality is confirmed, attach the faceplate or cover provided with the receptacle. Ensure it is securely fastened.
It is important to note that electrical work should be performed by a qualified electrician if you are unsure about any aspect of the installation process. Always follow the manufacturer's instructions and local electrical codes for safe and proper installation.
Add New Comment