Answer
Oct 30, 2024 - 04:01 AM
Installing the Faith GLS-20A-IV Non-Tamper Resistant Receptacles can be more complicated than installing a conventional receptacle. Here is a step-by-step guide to help you with the installation process:
1. Turn off the power: Before working with wiring, always turn off the power at the service panel to prevent severe shock or electrocution.
2. Understand basic wiring principles and techniques: It is important to have a basic understanding of wiring principles and techniques before installing the receptacle.
3. Identify the LINE and LOAD cables: The receptacle has two types of cables - LINE and LOAD. The LINE cable delivers power from the service panel to the receptacle, while the LOAD cable delivers power from the receptacle to another receptacle in the circuit.
4. Disconnect the wires: If you are replacing an old receptacle, pull it out of the electrical box without disconnecting the wires. If you see one cable (2-3 wires), it is the LINE cable. If you see two cables (4-6 wires), follow the procedure for a box with two cables.
5. Connect the wires: Depending on the type of cable, connect the wires to the appropriate terminals on the receptacle. For a box with one cable, connect the white wire to the WHITE terminal (Silver) and the black wire to the HOT terminal (Brass or Black). For a box with two cables, connect the white wires to the WHITE terminals and the black wires to the HOT terminals. Also, connect the grounding wires if present.
6. Complete the installation: Fold the wires into the box, keeping the grounding wire away from the WHITE and HOT terminals. xxxx the receptacle to the box and attach the faceplate.
7. Test your work: After installation, it is important to test the receptacle to ensure it is wired correctly. Plug a lamp or radio into the receptacle and turn on the power. Press the TEST button on the receptacle to trip it. If the lamp or radio turns off, the GFCI has been installed correctly.
It is important to follow the instructions provided in the user guide and consult a qualified electrician if you are unsure or have any concerns about the installation process.
Add New Comment