User Manual Q&AAnswer
Oct 29, 2024 - 03:05 AM
Installing the UNIDEN R4 Extreme Long-Range Laser Detector in your vehicle is a relatively straightforward process. Here are the steps to follow:
1. Mounting the Detector:
- Choose a suitable location on your vehicle's windshield or dashboard for mounting the detector. Ensure it has a clear view of the road ahead.
- Clean the mounting surface thoroughly to ensure proper adhesion.
- Attach the mounting bracket to the detector by aligning the slots on the bracket with the corresponding tabs on the detector. Slide the bracket until it clicks into place.
- Peel off the protective backing from the adhesive on the mounting bracket and firmly press it onto the chosen location.
2. Connecting the Power:
- Locate your vehicle's power outlet (cigarette lighter socket).
- Connect the power cord's plug into the power outlet.
- Route the power cord along the vehicle's interior, making sure it is not obstructing any controls or impeding safe driving.
- Secure any excess cord length using cable clips or by tucking it away neatly.
3. Adjusting the Detector:
- Once the detector is powered on, it will perform a self-test and display the firmware version.
- Adjust the detector's position on the mounting bracket to ensure the display is easily visible to the driver.
- Tilt and rotate the detector as needed to achieve the desired viewing angle.
4. Testing and Calibration:
- Take your vehicle to an open area away from other radar sources.
- Drive at a moderate speed and observe the detector's display for any radar or laser signals.
- If the detector detects signals, it is functioning correctly.
- To calibrate the detector, refer to the user's manual for specific instructions on adjusting sensitivity and other settings.
Please note that it's essential to consult the user's manual provided with the UNIDEN R4 Extreme Long-Range Laser Detector for detailed installation instructions and any specific considerations for your vehicle model.
Add New Comment