User Manual Q&AAnswer
Sep 26, 2024 - 01:04 AM
To set up the SHARP SPC1038 Atomic Wall Clock, follow these steps:
1. Setting up the Transmitter:
- Remove the battery door and insert 2 AA batteries into the battery compartment, following the polarities marked.
- Slide the switch to Channel 1 and press the RESET button to set the transmitter.
- Press the CHANNEL button at the back of the clock to set channel 1.
- Lock the transmitter battery door with the xxxx .
- Place the units away from metal objects and electrical appliances to minimize interference.
- Position the receiver within the effective transmission range of 30 meters.
- If the Channel 1 signal is not received properly, change the transmitter slide button to Channel 2 or 3. Press the CHANNEL button on the clock to 2 or 3 respectively.
- Press and hold the CHANNEL button for three seconds to find a new channel.
2. Quick Start Guide:
- Insert batteries into the remote sensor and set the Channel to 1.
- Insert batteries into the clock and set the Channel to 1.
- Turn on the Daylight Savings Button.
- Choose your time zone.
- Set the time and date manually or wait for the clock to receive the atomic signal.
3. Clock Display:
- The clock display shows time, calendar, indoor and outdoor temperature, signal strength indicator, daylight saving, and time zone.
4. Signal Strength Indicator:
- The SIGNAL indicator displays signal strength in 4 levels. A flashing wave segment means time signals are being received.
5. Using the Wall Mount:
- Use the recessed hold on the back of the clock to hang it.
- Hang or place the separate wall mounting part of the transmitter in an area protected from direct rain.
- Mount the stand and place the transmitter into the stand on the wall.
6. Setting Switch:
- Slide the switch to select a different setting mode (LOCK, TIME SET, CALENDAR SET).
7. Time Zone Setting:
- Slide the SETTING switch to TIME SET or CALENDAR SET.
- Press the UP and DOWN buttons to change the value and press the ENTER button to confirm the setting.
- Follow the sequence: Hour > Minute (TIME) and Year > Month > Date > Language (CALENDAR).
- Once the time or calendar is set, slide the switch to LOCK.
8. Battery Replacement:
- If the low battery indicator appears beside the outdoor temperature of the main unit, replace the transmitter batteries.
- If the low battery is displayed at the top left corner, replace the atomic clock batteries.
Please refer to the SHARP SPC1038 Atomic Wall Clock User Manual for more detailed instructions and illustrations.
Add New Comment