Answer
Sep 06, 2024 - 12:36 AM
To install the Cortelco 255415-VBA-20M Single Line White Wall Telephone, you will need a modular wall jack at the desired location. Follow these steps for installation:
1. For desk mounting: Use the long modular line cord provided. Plug one end of the line cord into the connector on the back of the telephone and the other end into the modular wall jack. To disconnect the telephone, press the spring clip on the line cord plug and pull it out.
2. For wall mounting: Insert the modular plug from the short cable on the back of the phone into the wall jack. Align the slotted holes on the back of the phone with the mounting studs on the wall jack. Gently pull down on the telephone until it locks in place. Older versions of the wall telephone may have a gray sliding plug instead of a short cord. Insert this plug into the wall jack and mount as described above.
Please refer to the instruction manual for visual illustrations and additional information on installation.
Note: It is important to follow safety precautions mentioned in the manual, such as not installing telephone wiring during a lightning storm and not touching uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.
Add New Comment