User Manual Q&AAnswer
Aug 27, 2024 - 03:12 AM
To assemble the , follow these steps:
1. Attach Stabilizers to the Main Frame: Make sure the transport wheels on the front stabilizer point forward, and the Schwinn decal on the rear stabilizer faces outward from the machine.
2. Install Console Mast, Mast Gasket, and Top Shroud on Main Assembly: Make sure the Console Cable connector does not fall into the Console Mast. Align the clips on the cable connectors and make sure the connectors lock. Be sure the tabs on the Top Shroud snap into the Main Assembly.
3. Install Handlebars on Console Mast: Do not crimp the cables. Put the Handlebar in the bracket, adjust the Handlebar to the desired angle, and install the T-handle through the holes. Use the pull cable in the Handlebar Mount to route the HR cable through the slot under the Handlebar Mount to the top of the mast. Fully tighten the T-handle to keep the Handlebar in position. Push the cover into position on the Handlebar Mount.
4. Install Console on Console Mast: Remove the pre-installed screws from the back of the Console before you connect the cables. Do not crimp the cables.
5. Install Seat Post on Frame: Make sure the Adjustment xxxx engages the Seat Post. Do not set the Seat Post position higher than the stop mark on the tube.
6. Attach Seat to Seat Post: Be sure the Seat is straight. Tighten the nuts on the Seat bracket to hold the Seat in position.
7. Install Pedals: The Left Pedal is reverse-threaded. Be sure to attach the Pedals on the proper side of the Bike. The Left Pedal has an "L", and the Right Pedal has an "R".
8. Install Water Bottle Holder: The hardware is pre-installed on the Console Mast.
9. Connect AC Adapter.
10. Final Inspection: Inspect your machine to ensure that all hardware is tight and components are properly assembled.
Please refer to the Schwinn 130 Upright Bike Owner's Manual for more detailed instructions and illustrations.
Add New Comment