User Manual Q&AAnswer
Aug 10, 2024 - 12:49 AM
To calibrate the touch control feature on the 360 Lighting 23X82 Ledger USB Table Lamp, please follow the manufacturer's instructions provided in the user manual. Here are the general steps you can take to calibrate the touch control feature:
1. Make sure the lamp is plugged into a power source and turned on.
2. Locate the touch control area on the lamp base. This is usually a designated spot where you can touch to control the lamp.
3. Depending on the specific model of the lamp, there may be different touch gestures required to operate the lamp. Refer to the user manual for the specific touch gestures for your lamp model.
4. Follow the instructions in the user manual to calibrate the touch control feature. This may involve touching and holding the touch control area for a certain period of time or performing specific touch gestures.
5. Once the touch control feature is calibrated, test its responsiveness by touching the designated area to turn the lamp on or off. If the lamp still does not respond consistently, repeat the calibration process.
If you are still experiencing issues with the touch control feature after calibrating it, please refer to the troubleshooting section in the user manual or contact the manufacturer's customer support for further assistance.
Add New Comment