User Manual Q&AAnswer
Jul 31, 2024 - 02:44 AM
To adjust the sensitivity of the dusk-to-dawn sensor on the LONEDRUID B07R4SQSJB Dusk to Dawn Wall Light, please follow these steps:
1. Locate the sensor adjustment dial on the light fixture. This dial is usually located on the bottom or side of the fixture.
2. Use a small screwdriver or similar tool to turn the sensor adjustment dial. Turning the dial clockwise will increase the sensitivity, causing the light to turn on earlier in the evening. Turning the dial counterclockwise will decrease the sensitivity, causing the light to turn on later in the evening.
3. Test the sensitivity by covering the sensor with your hand or a piece of cardboard. Remove the cover and observe the light to see if it turns on at the desired level of darkness. Repeat the adjustment process as needed until you achieve the desired sensitivity.
Note: It's important to avoid covering the sensor for an extended period of time, as this may cause the light to stay on continuously or not turn on at all. Additionally, make sure to avoid pointing the sensor directly at a bright light source, as this may affect its performance.
For more detailed instructions and illustrations, please refer to the "Adjusting the Sensor" section in the LONEDRUID B07R4SQSJB Dusk to Dawn Wall Light Instruction Manual.
Add New Comment