User Manual Q&AAnswer
Jul 24, 2024 - 03:54 AM
Replacing the grinding stone on the IREDOON MC-05 Low Vibration Electric Pet Nail Grinder is a simple process. Here are the step-by-step instructions:
1. Make sure the grinder is turned off and disconnected from the power source before replacing the grinding stone.
2. Locate the grinding stone on the grinder. It is usually located at the tip of the grinder and secured with a xxxx or a twist-lock mechanism.
3. If there is a xxxx , use a screwdriver to loosen and remove it. If there is a twist-lock mechanism, twist it counterclockwise to unlock and remove the grinding stone.
4. Once the grinding stone is removed, inspect it for any signs of wear or damage. If it is worn down or damaged, it is recommended to replace it with a new grinding stone.
5. Take the new grinding stone and align it with the slot or attachment point on the grinder. Make sure it is securely in place.
6. If there was a xxxx , insert it back into the slot and tighten it with a screwdriver. If there was a twist-lock mechanism, twist it clockwise to lock the new grinding stone in place.
7. Once the new grinding stone is securely attached, you can turn on the grinder and resume grooming your pet's nails.
Note: It is important to regularly check the grinding stone for wear and replace it as needed to maintain optimal performance. Replacement grinding stones can usually be purchased separately or may come with the grinder as accessories.
Add New Comment