Answer
Jul 20, 2024 - 01:47 AM
Cleaning your Ventray 809 Slow Juicer Machine is essential for proper maintenance and to ensure optimal performance. Here are the step-by-step instructions for cleaning the juicer:
1. Switch OFF and unplug the power cord from the wall outlet.
2. Extract all the remaining pulp in the juicing bowl before stopping the juicer.
3. For easier clean-up, operate the juicer for an additional 30 seconds after the juice is extracted.
4. If the drum lid is stuck, press the REVERSE - OFF - FORWARD button in this order, switching back and forth 2 to 3 times to dislodge any stuck ingredients. Then place your hands on top of the drum lid and firmly press down while simultaneously turning the drum lid counterclockwise to open.
5. Turn the drum lid counterclockwise to open.
6. Remove the juicing xxxx , strainer, and rotation wiper unit from the juicing bowl. Clean them thoroughly using the provided brush.
7. Clean the juicer immediately after each use. If remaining residue in the juicer dries up, it can make disassembling and clean-up difficult. The excess buildup can also cause poor performance in future uses.
8. For easier disassembly, place the top-set in the sink and run water through it from the top.
9. Thoroughly dry the bottom of the juicing xxxx where it connects to the metal cylinder shaft on the base.
10. Place the juicing bowl under running water and unplug the compression silicone to clean the pulp spout.
11. Soak the juicing bowl in a solution of warm water with baking soda or a little bit of bleach to clean any excess buildup.
12. Rinse all the parts thoroughly with water.
13. Allow the parts to air dry completely before reassembling the juicer.
14. Once all the parts are dry, reassemble the juicer according to the instructions in the manual.
15. Always make sure the juicer is switched OFF and unplugged from the power outlet when not in use.
By following these cleaning instructions, you can maintain the performance and longevity of your Ventray 809 Slow Juicer Machine.
Add New Comment